Pressure sensor 10bar 1/8 NPT 27 0-5v (only air, no vaccum) PX3AN2BS150PSAAX

Pressure sensor 0bar to 10bar. 0-5v output. +5 V supply from the ECU.
NPT 1/8 thread. Support for this sensor in MaxxECU.
Only dry air!

Tablet holder Lenovo Smart TAB M8 (GEN2) (3d printed)

3D printed tablet holder for Lenovo SMART TAB M8 (GEN 2)

LENOVO TAB M8 (4TH GEN) 32GB WIFI 8inch GREY

Grey 8 inch tablet with 32GB internal storage, WIFI and Android 12.

MaxxECU MINI STANDARD (ECU, harness and accessories) (without internal CAN resistor)

Connector 12-way socket housing Molex 120G (PWM 2 stepper module)

ECU connector Mazda MX5 (40-pin)

ECU connector Honda K series (125-pin)

52mm Can Bus Gauge (MFD15 Gen2)

Standard 52mm (1.5 inch) round instrument (like VDO displays), OLED display.

PWM 2 Stepper IAC Control Module

This IAC stepper controller is designed to control a typical 4-wire IAC Stepper Motor from a ground switching PWM signal from your ECU.

Pressure sensor 35bar / 500PSI 0-5V (sealed gauge)

Pressure sensor 0bar to 35bar / 500PSI. 0-5v output. +5 V supply from the ECU.
NPT 1/8 thread.

MaxxECU PDM20 PREMIUM (PDM, harnesses and accessories)

Connector 4-way socket housing VAG sensor

Connector 4-way socket housing including pins for VAG sensors.

MaxxECU BMW M4 DCT (GS7D36SG) cable harness

Cable harness for the BMW M4 DCT 7-speed dual-clutch gearbox (GS7D36SG). Available in 2023.

MaxxECU PRO PREMIUM (ECU, harnesses, accessories and LSU 4.9)

MaxxECU RACE H2O PREMIUM (ECU, harnesses, accessories, LSU 4.9)

MaxxECU RACE PREMIUM (ECU, harnesses, accessories and LSU 4.9)

MaxxECU SPORT PREMIUM (ECU, harness, accessories, LSU 4.9)

MaxxECU STREET PREMIUM (ECU, harness, accessories and LSU 4.9)

Bosch MAP/IAT (50-400 kPa)

xHP WIFI OBD adapter (GEN2 DCT flash)

xHP WIFI adapter to custom flash the needed MaxxECU TCU firmware to the BMW GEN2 (F-series) DCT gearbox.

DCT E9x M3 TCU firmware flash (20bar)

Custom firmware increases the clutch pressures from 15.5bar to 20bar which therefore increases the transferred torque.