Input used with strain gauges with sequential gearboxes.
Shift force trigger settings
The force signal is continuously zeroed to correct for sensor drift and small external forces.
The min allowed time between 2 shift triggers. Used to ignore short force pulses that can happen during, or right after the shift.
Shift cut trigger
positive/negative trigger force
Starts the shift cut when the Shift force analog input is above/below the set threshold. The length of the shift cut is set by the shiftcut time table in Shiftcut settings.
Note: if you for example don't want a shift cut on down shift, set the negative trigger force to be outside of your negative shift force calibration.
positive/negative blip trigger
Trigger the throttle blip function when the Shift force analog input is above/below the set threshold. The length of the throttle blip is set by the blip time table in Throttle blip settings.
Note: if you for example don't want a throttle blip on up shift, set the positive trigger force to be outside of your positive shift force calibration.
1. Add a shift force sensor on the wired analog input.
2. Calibrate the shift force sensor, you can use any kind of unit, but Nm is preferable.