Please enable JavaScript to view this site.

MaxxECU online help

Note: The EGT Ref Temp (cold junction temperature) is continuously measured and compensated for by a PCB temperature sensor thermally coupled to the CMC connectors EGT pins.

Optional cold junction temp sensor is available, see AIN (temperature).

 

EGT Sensors

 

EGT input

Selects the function for the EGT input(s).

 

Sensor type

Specifies the type of sensors attached the the EGT input(s).

Type-K

Type-N

 

 

Sensor filter

 

EGT filter

Adds a filter to "slow down" EGT inputs, enable if you get small "spikes" from EGT input sensors.

Note: Higher number --> more filter.

 

 

Sensor error checking

 

Sensor error check

Enable/disable the error checking of connected EGT sensors.

 

 

Sensor calibration

 

Sensor calibration

Default - No offset adjustments.

User setting - Below offset adjustment is used to adjust EGT input values.

 

Offset adjustment

Offset adjustments added/removed to the EGT input(s) activated.

 

 

 

Examples

 

EGT input used anything else than just Exhaust Gas Temperature

clip0424

An EGT input used as input for example reading rear axle temperature. RealTime Data value will show up under Internal EGT section.

 

Sensor offset

clip0425

The above offset adjustment will add 10degree C to ALL EGT input(s) activated.

 

 

Use an EGT type-K input as IAT

See settings in Inputs --> Sensors (CLT,IAT,TPS).

 

clip1237

To use an EGT input as a IAT sensor, set type to ON EGT sensor input, and select the wired input.